Remove the grip from the packaging and clean your phone with rubbing alcohol or water. A small amount of either will not harm your phone and will help the Ohsnap grip stick!

Before sticking Ohsnap to your phone, identify the center of your phone - both vertically and horizontally. It’s important that your grip be perfectly centered for wireless charging to work properly.

Separate the steel ring from Ohsnap’s frame, then peel off the sticker. Next, place the ring (sticky-side-down) onto the center of your phone before massaging firmly. Wait overnight before proceeding. Allowing time for the adhesive to cure is necessary to ensure the grip sticks.

Place your Ohsnap onto the steel ring, then wiggle it around to make sure it’s locked securely in place. Now, you’re ready to use your new grip!

Simply slide your finger between the cap and bottom of your Ohsnap to use the grip! To rotate, firmly press against the ring and turn your phone. You can also pull your finger out and press firmly on the cap while rotating your phone.

To use the kickstand, insert the cap into the ridges on your Ohsnap grip. This will get easier as you understand the feel. You can also flip the cap into place with one finger to activate the kickstand. Rotate the kickstand to achieve different angles of elevation.

Stick your phone to any steel surface! To maintain magnetism on thinner surfaces, we recommend rotating the grip 90 degrees. You also can rotate your grip on a steel surface to find the angle that works best for you.